| How to use Window Stick - Instructions | |
|---|---|
1 |
Twist top of Window Stick to open battery compartment. Insert the required 23A 12V battery and close battery compartment.
 |
2 |
Twist to unlock. This allows you to adjust the length of your  Window Stick. |
3 |
Close sliding window or patio door. Adjust the size of the  Window Stick to fit into your sliding window or patio door frame, then twist to lock again. Now place into the track of your sliding window. Note: Hand tighten, over tightening may damage Window Stick. |
| Universal Clip - Instructions |
|---|
| Important - Read and understand instructions prior to installation. Window Stick Alarms Ltd is not liable for any damages or loss that may result from the installation of this product. We recommend that you test your battery regularly and replace it annually. |
Package Contents:
2 - # 8 Phillips ¾” screws.* 2 - # 8 Phillips 1 5/8” screws.* 1 – Block ** 1 – Universal Clip 
* Pre-drilling a 1/16” pilot hole recommended. ** Dual function: use as a spacer Block in window frames with a channel, or, as a stop Block for outside sliding patio doors & large sliding windows. |
Vertical Sliding Window – Universal Clip |
 |
| 1. Close window. 2. Choose location to install clip (figure 1 or figure 2). 3. Place Universal Clip into position. 4. Mark location of screw holes. Pre-drilling a 1/16” pilot hole is recommended. 5. Figure 1 - Use your Phillips screwdriver and the two ¾” screws to attach the Universal Clip. Do not screw into glass. 6. Figure 2 - Use your Phillips screwdriver and the two 1 5/8” screws to attach the Universal Clip if Block is needed. Use ¾” screws if Block is not needed. |
| Outside Sliding Patio Door–Block & Universal Clip |
 |
| Figure 3 - Clip Installation (Optional)
1. Place Universal Clip into position as displayed in Figure 3. Ensure Window Stick is in-line with Block. Figure 4 - Block Installation 1. Close patio door and position Block as displayed in Figure 4. |
Large Inside Sliding Window – Block |
 |
| 1. Close window. 2. Open Window Stick 3 inches and lock. 3. Place Window Stick into frame. 4. Mark location of screw holes. Pre-drilling a 1/16” pilot hole is recommended. 5. Use your Phillips screwdriver and the two 1 5/8” screws to attach the Block. |
Inside Sliding Window - Universal Clip |
 |
| 1. Place Universal Clip into position as displayed in Figure 6 or 7. 2. Mark location of screw holes. Pre-drilling a 1/16” pilot hole is recommended. 3. Figure 6 - Use your Phillips screwdriver and the two 1 5/8” screws to attach the Universal Clip if Block is needed. 4. Figure 7 - Use your Phillips screwdriver and the two ¾”screws to attach the Universal Clip. Do not screw into glass. |